|
|
 |
|
Overview |
 |
|
|
Contact Information |
| |
| Lean Cost Machines |
| Erich Schillinger |
· Phone: +49(0)7834-866-155
· E-Mail: e.schillinger@supfina.com |
|
|
|
Supfina LeanCostMachine®
|
Lean Cost Machines will be introduced in cases where inexpensive production solutions are needed on short-notice. This is possible because the Lean Cost Machines are built using a modular, thus very flexible, machine concept as well as through the means of relevant series production.
|
|
|
|
Supfina LeanCostMachines® can be loaded by hand or can be adapted to various loading/un-loading systems: magazine, gantry, robot or conveyor belt among others. Whatever the case may be the Lean Cost Machine line can be integrated to work with the most cost-effective handling system the customer requires, whether the call is for piece work or production work.
The Supfina LeanCostMachines® are capable of finishing not only simple-geometry pieces such as flat sealing surfaces, valve tappets, or pump gears, but also complex geometry parts such as transmission shafts, cam shafts, balance shafts and eccentric shafts. Essentially all materials can be superfinished from soft steel to super hard ceramic.
|
| Supfina LeanCostMachine® |
 |
Supfina LeanCostMachine®
The Supfina LeanCostMachine® is a modular machine concept, which allows for the use of stone finishing, band finishing, cup-wheel finishing and also brushing.
The coolant system of the Supfina LeanCostMachine® can be outfitted to use an emulsion-based coolant or a finishing oil-based coolant in either flood or mist configurations.
It is also well suited to run as a Supfina Dryfinish® system. Both horizontal and vertical configurations are available. |
(pdf) ->
|
 |
| |
| |
|
|
|
|
